![]() Some great resources on programming this microcontroller are listed below. The video is almost 50min long, so take your seat and enjoy.ĪTTINY10 cannot be programmer using the standard AVR ISP programming interface but instead it uses TPI interface which requires 12V programming. This video can be considered as a introduction tutorial on ATTINY10 and the details covered will get you started with this tiny mcu. installed, and that youhave set your workspace folder to a known location. NOTE: This tutorial assumes that you already have. SUPPLEMENTAL MATERIALS µPAD v2.0 Schematic. He covers, how to wire a small converter and an AVR High Voltage Programmer, how to get started with Atmel Studio 7 and basic I/O, how to blink a LED and view the signal with an oscilloscope, how to use interrupts to bit-bang a serial protocol to get data out of the device and how to use the ADC to get readings from attached sensors. REQUIRED MATERIALS GPIOOutput.asm µPAD v2.0 with USB A/B connector cable. Here is a nice video from Ben Heck describing how to program and use the smallest AVR microcontroller, the ATTINY10.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |